Configuring VM-Series ethernet1/1 with WAN Zone

After logging in, select the Network tab to see a list of ethernet interfaces. Click ethernet1/1 and configure as per the following screenshot.

  1. Select the Network tab.

  2. Click ethernet1/1.

  3. Select "layer3" for Interface Type.

  4. Select the Config tab in the popup Ethernet Interface window.

  5. Select the default for Virtual Router at Config tab.

  6. Click New Zone for Security Zone to create a WAN zone.

  7. At the next popup screen, name the new zone "WAN" and click OK.

    new_zone

  1. Select the IPV4 tab in the popup Ethernet Interface window.

  2. Select Static.

  3. Add the Private IP of eth1 firewall WAN NIC, as shown below.

    ipv4

  1. Click Commit. Once Commit is complete, you should see the Link State turn green at the Network page for ethernet1/1.